Leica GPS1200 Series Technical Reference Manual page 263

Hide thumbs Also See for GPS1200 Series:

Table of Contents

ReOpen Any Line Opens a line from a list of all lines which are currently

To start a new sequence of point ID's type over the

For an individual point ID independent of the ID

template SHIFT INDIV (F5). SHIFT RUN (F5)

changes back to the next ID from the configured

ID template. Refer to "19.1 ID Templates".

The linework flag to be stored with the point. The

options available depend on whether a line/area is

currently open.

No linework flag is stored.

Opens a new line when the next point is stored. Any

line/area which is currently open is closed and the last

point belonging to that line/area is given the

End Line/Close Area linework flag. The point may or

may not be stored with a point code.

Stores the linework flag for a curve through the next

three measured points and continues a line/area.

stored in the job when the next point is stored. The

last code used with the reopened line is automatically

selected when the point is stored.

Any line/area which is currently open is closed and

the last point belonging to that line/area is given the

End Line/Close Area linework flag.

Show Quick Links

Table of Contents