Real-Time Rover Operations - Leica GPS1200+ Applications Manual

9.5

Real-Time Rover Operations

Requirements
Access step-by-
step
SURVEY
Survey: Job Name,
Survey page
Survey - General
• <R-Time Mode: Rover> in CONFIGURE Real-Time Mode
• A real-time interface is configured correctly.
• The according real-time device is attached and working properly.
Step Description
1. Refer to "1.1 Starting an Application Program" to access SURVEY Survey
Begin.
2. SURVEY Survey Begin
Check the settings. Select a typical configuration set for real-time rover
operations.
3. CONT (F1) to access SURVEY Survey: Job Name.
The arrow at the real-time device and real-time status icon flashes when
real-time messages are being received.
Fixing ambiguity begins. The current position status is indicated by the
position status icon. When working with code only corrections, an ambi-
guity solution is not attempted.
The position mode icon is the moving icon. This indicates that the antenna
can be moved around and that no static observations are being recorded.
The fields shown are those from a typical configuration set for real-time rover oper-
ations. The screen described consists of the Survey page and the Map page. The
explanations for the softkeys given below are valid for the Survey page. The majority
of softkeys is identical to those available for static operations. Refer to "9.2 Static
Operations" for information on the identical softkeys.
SHIFT CONEC (F3) and SHIFT DISCO
SHIFT AVGE (F2)
GPS1200+
(F3)
To dial the number of the reference
station configured in the active
configuration set and to hang up
immediately after the survey is
completed. Available for real-time
devices of type digital cellular phone
or modem. Available for <Auto
CONEC: No> in CONFIGURE GSM
Connection.
To check the residuals for the aver-
aged position. Available for <Aver-
aging Mode: Average> and for more
than one measured coordinate triplet
recorded for the same point.
141