Default Ip Service (Conferencing Service) - Polycom RMX 2000 Administrator's Manual

Chapter 8-Network Services

Default IP Service (Conferencing Service)

8-2
Management Network parameters include the IP address of the Control
Unit, whose IP address can be used by the administrator, or control unit
service personnel, to connect to the Control Unit should the RMX become
corrupted or inaccessible. For more information, see Appendix F,
"Permanent Management Network" on page F-1.
During First Time Power-up, the Management Network parameters can be
set either via a USB key or by using a cable to create a private network.
For more information about First Time Power-up see the RMX 2000 Getting
Started Guide, "Procedure 3: First-time Power-up and Connection to MCU" on
page 2-8.
The Default IP Service (Conferencing Service) is used to configure and
manage communications between the RMX and conferencing devices
such as endpoints, gatekeepers, SIP servers, etc.
The Default IP Service contains parameters for:
• Signaling Host Address
• MPM boards (media processors)
• External Conferencing Devices
Calls from all external entities are made to the Signaling Host, which
initiates call set-up and assigns the call to the appropriate MPM board.
Conferencing related definitions such as environment (H.323 or SIP) are
also defined in this service.