Default Ip Service (Conferencing Service) - Polycom RMX 1500 Administrator's Manual

Default IP Service (Conferencing Service)

Modifying the Management Network
The Default IP Service (Conferencing Service) is used to configure and
manage communications between the RMX and conferencing devices
such as endpoints, gatekeepers, SIP servers, etc.
The Default IP Service contains parameters for:
• Signaling Host IP Address
• MPM, MPM+ and MPMx media cards (Media Processors
• External conferencing devices
Calls from all external IP entities are made to the Signaling Host, which
initiates call set-up and assigns the call to the appropriate MPM / MPM+ /
MPMx media card.
From Version 7.1, MPM media cards are not supported.
Conferencing related definitions such as environment (H.323 or SIP) are
also defined in this service.
Most of the Default IP Service is configured by the Fast Configuration
Wizard, which runs automatically should the following occur:
• First time power-up.
• Deletion of the Default IP Service, followed by a system reset.
For more information, see the RMX 1500/2000/4000 Getting Started Guide,
"Procedure 1: First-time Power-up" on page 2-22.
Changes made to any of these parameters only take effect when the RMX unit
is reset. An Active Alarm is created when changes made to the system have not
yet been implemented and the MCU must be reset.
The Management Network parameters need to be modified if you want to:
• Connect directly to the RMX from a workstation
• Modify routes
• Modify DNS information
Polycom RMX 1500/2000/4000 Administrator's Guide
14-3