Polycom RMX 2000 Administrator's Manual page 232

Appendix B-Active Alarms
Category Code
Installer– NEW_ACTIVATION_KEY_
General LOADED
NEW_VERSION_INSTALLED
Logger– BAD_FILE_SYSTEM
General
BAD_HARD_DISK
FAILED_TO_INIT_FILE_
SYSTEM
McmsDaemon– PROCESS_FAILED_
General STARTUP
PROCESS_TERMINATED
RESET_MCU
RESET_MCU_INTERNAL
B-6
Description
A new activation key was loaded:
Reset the MCU.
A new version was installed:
Reset the MCU.
Log file system error:
The Log File System is disabled. Log files not
found.
Hard disk error:
Hard disk not responding.
Failed to initialize the file system.
Process failed:
[Process name] failed to start.
Process terminated:
[Process name] terminated.
MCU reset:
Reset cause: [reset source].
Internal MCU reset:
• McmsDaemon reset due to policy decision:
[Process failed [abs crash counter: crash
counter] :process name].
• McmsDaemon reset due to policy decision:
[Process failed [abs crash counter: crash
counter] :process name] ; Cannot reset while
system is in DEBUG mode.
•
Power down signal was detected.
•
[CS Component Failure; unit type:
[NonComponent\CSMngnt\CSH323\CSSIP]\
CS Component Failure; unit type: (invalid:
[unit type])\No connection with CS]; Cannot
reset while system is in DEBUG mode.