Polycom RMX 2000 Administrator's Manual page 212

Chapter 12-Hardware Monitoring
12-12
The Diagnostics pane is displayed at the bottom of the screen.
Repositioning the pane is enabled by clicking and dragging the pane
to the desired location on the screen, i.e. right side bar (displayed
below).
Diagnostics Test Selection
Diagnostics Test Monitoring
3 Select the Test(s) to perform in the section labeled Diagnostics Test
Selection by marking the check boxes in the TestActive column.
Each column in the Diagnostics Test Selection is interchangeable.
Click, hold and slide a column left or right to the desired position.
The type of tests that can be selected in the Test Selection are
dependant on the hardware component. Each component enables
different tests.