Connecting To The Permanent Management Network; Access To The Permanent Management Network - Polycom RMX 2000 Administrator's Manual

Appendix F-Configuring Direct Connections to RMX

Connecting to the Permanent Management Network

F-6
8
Log out of the RMX Web Client and log in again.
The Fast Configuration Wizard starts if:
• The RMX cannot access the Default IP Service. This happens during
First Time Power-up, before the service has been defined.
• The Default IP Service has been deleted, followed by an RMX reset.
For more information about First-time Power-up and the Fast Configuration
Wizard see the RMX 2000 Getting Started Guide, "Procedure 3: First-time
Power-up and Connection to MCU" on page 2-8.

Access to the Permanent Management Network

Access to the Permanent Management Network is via a cable connected to a
workstation. The Permanent Management Network is accessible only via the
dedicated LAN 3 port.
To connect to the Permanent Management Network:
1
Connect the cable between the RMX's LAN 3 port and the LAN port
configured on the workstation.
2 Start the RMX Web Client application on the workstation, by entering
http://169.254.192.10
browser's address line and pressing Enter.
LAN 3 Port
(the Control Unit IP Address) in the