Polycom RMX 2000 Administrator's Manual page 206

Chapter 12-Hardware Monitoring
12-6
Table 12-4 MCU Properties - Event Log (Continued)
Column
Status
Ipmb Address(hex)
3
Click the Active Alarms tab to view alarms related to the RMX 2000,
i.e. temperatures and main power sensors.
The Active Alarms tab displays fields that relate to faults and errors
detected on the RMX by sensors. The Active Alarms tab is divided
into two sections: HW Alarm List and SW Alarm List. Each section's
alarm list can be saved as a *.xls file by clicking the Save HW Alarm
List and Save SW Alarm List buttons respectively. Each alarm list
color codes the severity of the alarm; Critical (RED), Major
(ORANGE) and Normal (GREEN).
If you connected to the Hardware Monitoring via the Shelf Management server,
the SW Alarm List section will not be displayed.
To view the Card Properties:
1
In the Hardware Monitor pane, either double-click or right-click and
select properties for the desired hardware component.
The following information is displayed:
Table 12-5 Card Properties - General Info
Field
HW Version
SW Version
Serial Number
Card Type
Board Part
Number
Description
The sensor's active status.
Contains all the internal IPMI network addresses on
the IPMB bus, i.e. 0x20 (Switch), 0x86 (MFA), etc...
Description
The hardware component's version number.
The software version number installed.
The hardware component's serial number.
Displays the type of card that occupies the slot.
The part number of the HW component's board.