Polycom RMX 2000 Administrator's Manual page 219

Table A-1 Audio Disconnection Cause (Continued)
Cause Message
H323 call closed. Unknown
reason
H323 call close. Closed by
MCU
H323 call closed. Faulty
destination address
H323 call closed. Small
bandwidth
H323 call closed.
Gatekeeper reject ARQ
H323 call closed. No port
left
H323 call closed.
Gatekeeper DRQ
H323 call closed. No
destination IP address
H323 call. Call failed prior
or during the capabilities
negotiation stage
H323 call closed. Audio
channels didn't open
before timeout
H323 call closed. Remote
sent bad capability
H323 call closed. Local
capability wasn't accepted
by remote
H323 failure
H323 call closed. Remote
stop responding
Polycom RMX 2000 Administrator's Guide
Description
The reason for the disconnection is unknown, for
example, the endpoint disconnected without
giving a reason.
The MCU disconnected the call.
Incorrect address format.
The gatekeeper allocated insufficient bandwidth
to the connection with the endpoint.
The gatekeeper rejected the endpoint's ARQ.
There are no ports left in the IP card.
The gatekeeper sent a DRQ.
For internal use.
The endpoint did not send its capabilities to the
gatekeeper.
The endpoint did not open the audio channel.
There was a problem in the capabilities sent by
the endpoint.
The endpoint did not accept the capabilities sent
by the gatekeeper.
Internal error occurred.
The endpoint stopped responding.
A-3