Polycom RMX 2000 Administrator's Manual page 109

Most of the Default IP Service is configured by the Fast Configuration
Wizard, which runs automatically should the following occur:
• First Time Power-up
• Default IP Service is deleted, followed by an RMX reset.
For more information about First Time Power-up see the RMX 2000 Getting
Started Guide, "Procedure 3: First-time Power-up and Connection to MCU" on
page 2-8.
Changes made to any of these parameters only take effect when the RMX unit
is reset. An Active Alarm is created when changes made to the system have not
yet been implemented and the MCU must be reset.
Polycom RMX 2000 Administrator's Guide
8-3