Polycom RMX 2000 Administrator's Manual page 213

Additional test parameters can be set before performing the tests, as
described below.
Table 12-8 Tests Selection - Additional Test Parameters
Parameter
Quick Test Mode
Loop Test
Stop On Fail
Run All Test
4
Click the Run Selected Tests button.
The selected tests are initialized. This process may take some time.
Click Stop Running Test to end all the diagnostic tests. The MCU
completes the current test running and then stops all remaining tests.
For more information on test results, see "Diagnostics Monitoring" on
page 12-14.
5 Repeat procedures 1-6 to run diagnostics for each of the other
hardware components.
Polycom RMX 2000 Administrator's Guide
Description
Runs only the tests that are marked Quick in the
Quick column. Particular tests in the system are not
as complicated and thus take less time to analyze.
These tests are indicated with a check mark in the
Quick column.
Enter the amount of times the test is to repeat itself
in succession.
Stops tests upon a fail.
Runs all tests listed in the TestActive column for the
hardware component.
12-13