Polycom RMX 2000 Administrator's Manual page 218

Appendix A-Disconnection Causes
A-2
Table A-1 Audio Disconnection Cause (Continued)
Cause Message
H323 call close. No control
port left
H323 call close. No port
left for videocont
H323 call closed. Small
bandwidth
H323 call closed. No port
left
Caller not registered
H323 call closed. ARQ
timeout
H323 call closed. DRQ
timeout
H323 call closed. Alt
Gatekeeper failure
H323 call closed.
Gatekeeper failure
H323 call closed. Remote
busy
H323 call closed. Normal
H323 call closed. Remote
reject
H323 call closed. Remote
unreachable
Description
The required control ports exceed the number of
ports allocated to control data in fixed ports.
The required video content ports exceed the
number of ports allocated to video content in
fixed ports.
The gatekeeper allocated insufficient bandwidth
to the connection with the endpoint.
There are no free ports left in the IP card.
The calling endpoint is not registered in the
gatekeeper.
The endpoint sent an ARQ message to the
gatekeeper, but the gatekeeper did not respond
before timeout.
The endpoint sent a DRQ message to the
gatekeeper, but the gatekeeper did not respond
before timeout.
An alternate gatekeeper failure occurred.
A gatekeeper failure occurred.
The endpoint was busy. (Applicable only to dial-
out)
The call ended normally, for example, the
endpoint disconnected.
The endpoint rejected the call.
The gatekeeper could not find the endpoint's
address.