Enabling Sd; System Flag Setting - Polycom RMX 2000 Administrator's Manual

Enabling SD

• SD is supported by the cascaded link. For more information about
Cascading, see "Cascading Conferences" on page 6-19.
For the MCU to allocate SD resources to endpoints all of the following
criteria must be met:
• The MAX_CP_RESOLUTION flag must be set to SD15 or SD30.
• The endpoint's resolution capabilities must be higher than CIF.
• The appropriate Quality parameter must be selected in the
conference Profile. For more information, see "Defining Profiles" on
page 1-6.
• The RMX must have available resources (ports).

System Flag Setting

1
Click Setup>System Configuration.
The System Flags dialog box opens.
2
Set the MAX_CP_RESOLUTION flag to one of the following values:
Table 6-2 System Flag – MAX_CP_RESOLUTION Values
Flag Value
SD30 (default)
SD15
CIF
3
Click OK.
For more information about setting system flags, see "System
Configuration" on page 11-5.
Reset the MCU for flag changes to take effect.
Polycom RMX 2000 Administrator's Guide
System SD Capability
Each endpoint may declare up to SD30 capabilities.
Each endpoint may declare up to SD15 or 2CIF30
capabilities.
2CIF30 uses the resolution of 2CIF (704X288) at 30
frames per second.
No SD capabilities.
6-3