Replacing An Xgm3/Xgm3S Series Port Option Card In A Summit X460 Series Switch - Extreme Networks Summit X150 Series Hardware Installation Manual

Replacing an XGM3/XGM3S Series Port Option Card in a Summit
X460 Series Switch
Note
After you replace an XGM3-2sf port option card, you must reboot the switch before the ports
on the card will become operational.
To replace an XGM3/XGM3S series port option card:
1 Attach an ESD-preventive wrist strap to your bare wrist and connect the metal end to an
appropriate ground point on the rack.
2 Loosen the captive retaining screws on the option card until they are completely loose (see
343: Removing an XGM3-2sf Port Option Card
3 Carefully slide the option card out of the slot.
Figure 343: Removing an XGM3-2sf Port Option Card
4 Carefully slide the replacement option card into the switch.
Figure 344: Installing an XGM3-2sf Port Option Card
Summit Family Hardware Installation Guide
Replacing Port Option Cards and VIMs
on page 356).
Figure
356