Installing An 850 W Dc Power Supply In A Summit X650 Series Switch - Extreme Networks Summit X150 Series Hardware Installation Manual

5 Push the power supply in until the latch snaps into place.
Caution
Do not slam the power supply into the switch.
Figure 249: Installing a Power Supply
6 To install a second power supply, repeat steps
Note
If power supplies are not installed in both power supply bays, be sure to install a cover
over the unoccupied bay. Unoccupied bays must always be covered to maintain proper
system ventilation and EMI levels.
7 Connect an appropriate AC power cord to the power input socket; connect the other end of the
power cord to a grounded AC power outlet.
Warning
Always be sure that the source outlet is properly grounded before plugging the AC power
cord into the unit.

Installing an 850 W DC Power Supply in a Summit X650 Series Switch

Caution
Make sure that the DC power supply circuit is not overloaded. Use proper over-current
protection, such as a circuit-breaker, to prevent over-current conditions. You may use up to a
30-Amp breaker.
To install the 850 W DC power supply, perform the following tasks in the order listed:
1 Prepare the power cables and ground cable by attaching the provided connection lugs to the cables
(see next section).
Summit Family Hardware Installation Guide
Installing Summit Family Switches
5 on page 331 and 6 on page 331.
270