Replacing An Xgm3/Xgm3S Series Port Option Card In A Summit X460 Series Switch - Extreme Networks Summit X150 Series Hardware Installation Manual

Chapter 12: Replacing Port Option Cards and VIMs
Figure 292: Removing a SummitStack Module
3 Carefully slide the replacement module or card into the switch
4 Align and tighten the captive retaining screws.
Figure 293: Installing a SummitStack Module
Replacing an XGM3/XGM3S Series Port Option Card
in a Summit X460 Series Switch
NOTE
After you replace an XGM3-2sf port option card, you must reboot the switch before the ports on the card
will become operational.
To replace an XGM3/XGM3S seriesport option card:
1 Attach an ESD-preventive wrist strap to your bare wrist and connect the metal end to an appropriate
ground point on the rack.
2 Loosen the captive retaining screws on the option card until they are completely loose
3 Carefully slide the option card out of the slot
350
SH_218
(Figure
SH_217
(Figure 294).
Summit Family Switches Hardware Installation Guide
293).
(Figure 294).