Extreme Networks Summit X150 Series Hardware Installation Manual page 304

The EPS-T2 is a rack-mountable chassis or tray that holds one or two EPS-150DC power supplies. Each
EPS-150DC provides one-to-one redundancy to an attached Extreme Networks switch. You must install
the EPS-150DC power supply in the EPS-T2 tray.
Note
For centralized DC power connection, this product is intended to be installed in restricted
access locations (dedicated equipment rooms, equipment closets, or the like) in accordance
with Articles 110-16, 110-17, and 110-18 of the National Electric Code, ANSI/NFPA 70.
Caution
Do not use the rack-mount brackets to suspend the EPS-T2 from under a table or desk, or to
attach the EPS-T2 to a wall.
Rack-mount the EPS-T2
To install the EPS-T2:
1 Place the EPS-T2 upright on a secure surface, with the front facing you.
2 Remove the mounting bracket kit from the packaging.
3 Attach the mounting brackets:
a Place a mounting bracket over the mounting holes on one side of the EPS-T2 (see
Attaching the Mounting Bracket
b Insert the provided screws and fully tighten with a screwdriver.
Figure 282: Attaching the Mounting Bracket
c Repeat steps 2 and 3 for the other side of the EPS-T2.
4 Slide the EPS-T2 into a 19-inch rack and secure it using appropriate rack-mounting screws.
Summit Family Hardware Installation Guide
Installing Summit External Power Supplies
on page 304).
Figure 282:
304