Extreme Networks Summit X150 Series Hardware Installation Manual page 350

c Slide the spade terminal of the positive wire (–48 V RTN) under the captive square washer on
the positive terminal (labeled RTN).
Figure 337: Connecting the DC Power Cables (Part 1)
d Tighten both screws on the terminal block to 11 inch-pounds (see
Power Cables (Part 2)
5 Slide the cover into place over the terminal block (see
(Part 2) on page 350).
Figure 338: Connecting the DC Power Cables (Part 2)
6 Energize the DC circuit.
Summit Family Hardware Installation Guide
Replacing DC Power Supplies in Summit Family Switches
RTN
(+)
on page 350).
-48V
(–)
SH_111
Figure 338: Connecting the DC
Figure 338: Connecting the DC Power Cables
350