Extreme Networks Summit X150 Series Hardware Installation Manual page 221

Pre-installation Requirements
Installing the Summit X460 series switch requires two people to maneuver the switch and attach
mounting hardware.
Make sure there is adequate space behind the rack to provide access for installing power supplies, port
option cards, and stacking modules.
The following items are provided with the Summit X460 series switch:
•
Two rack mounting brackets adaptable for either a front-mount or mid-mount installation
•
Twelve screws for attaching the brackets to the switch enclosure
You need the following additional tools and equipment:
•
Four rack mounting screws
The screw size will vary based on your organization's rack system; screws are not provided.
•
Screwdriver for securing the switch to your organization's rack
The screwdriver size will vary based on the requirements of your organization's rack system.
•
AC power cord for each installed AC power supply
An AC power cord is not included with the Summit X460 series switch. You must obtain a power
supply cord that meets the requirements listed under
Switches and AC Power
•
ESD-preventive wrist strap for installing optional ports at the back of the switch
Mid-Mount a Switch in a Two-Post Rack
To mid-mount a Summit X460 series switch in a two-post rack:
1 Attach an ESD-preventive wrist strap to your bare wrist and connect the metal end to an
appropriate ground point on the rack.
2 On one side of the switch, set the bracket against the switch housing, with the flange toward the
back of the switch (see
3 Use six of the provided screws to secure the bracket to the switch housing.
Summit Family Hardware Installation Guide
Supplies.
Figure 192: Attaching a Rack-mounting Flange
Installing Summit Family Switches
Power Cord Requirements for AC-Powered
on page 222).
221