Extreme Networks Summit X150 Series Hardware Installation Manual page 346

a On each terminal, loosen the screw enough to allow the spade terminal to slide underneath the
captive square washer
b Slide the spade terminal of the negative wire (–48 V) under the captive square washer on the
negative terminal (labeled –).
c Slide the spade terminal of the positive wire (–48 V RTN) under the captive square washer on
the positive terminal (labeled +).
Figure 332: Connecting the DC Power Cables (Part 1)
d Tighten both screws on the terminal block to 7 inch-pounds (0.99 Newton meters)
the DC Power Cables (Part
Summit Family Hardware Installation Guide
Replacing DC Power Supplies in Summit Family Switches
(Connecting the DC Power Cables (Part
(+)
(–)
-48V
2)).
1)).
RTN
SH _ 161
(Connecting
346