Extreme Networks Summit X150 Series Hardware Installation Manual page 293

EPS-LD so that the power output connectors on the EPS-LD unit are on the same side as the external
connector on the connecting switch.
Caution
Do not use the rack-mount brackets to suspend the EPS-LD from under a table or desk, or to
attach the unit to a wall.
Note
An AC power cord is not provided with the EPS-LD power supply. See
Requirements for AC-Powered Switches and AC Power Supplies
selecting a power cord.
Rack-mount the EPS-LD Power Supply
Note
When installing an EPS-LD in a rack, make sure air vents are not restricted. Allow for elevated
ambient operating temperatures when the EPS-LD is installed adjacent to other equipment.
Be sure you mount the equipment in the rack so that the load is evenly distributed.
To rack-mount each EPS-LD unit:
1 Place the EPS-LD unit upright on a stable surface, with the side you want to face to the front of the
switch toward you.
2 Remove the mounting bracket kit from the packaging.
3 Attach the mounting brackets as follows:
a Place a mounting bracket over the mounting holes on one side of the unit (see the figure
below)).
b Insert the provided screws and fully tighten them using a screwdriver.
Figure 270: Attaching the Mounting Bracket
c Repeat steps
Summit Family Hardware Installation Guide
a and b for the other side of the EPS-LD unit.
Installing Summit External Power Supplies
Power Cord
for information about
293