Extreme Networks Summit X150 Series Hardware Installation Manual page 281

c Insert the provided M4 screw through the ring terminal and into the grounding stud on the front
of the switch
d Securely tighten the screw.
Figure 262: Grounding a Summit X670 Series Switch
The Summit X670 and X770 series switches are shipped without installed power supplies. You can
install two power supplies for a redundant power configuration. After the switch is secured to the rack,
install the necessary power supplies for your configuration. For instructions, see the following pages:
•
Installing a Summit 450 W or 550 W AC Power Supply
•
Installing a Summit 450 W or 550 W DC Power Supply
Note
If you are installing a VIM4 module in the Summit X670V-48x switch, install it in the switch
before you connect the switch to power (see
Summit X480, X650, or X670 Series
Installing the X670 or X770 Switch in a Cabinet or Four-Post Rack
To install the Summit X670 or X770 series switch in a cabinet or four-post rack:
1 Attach each front-mounting bracket as follows:
a Set the bracket against the switch housing, with the flange even with the front panel of the
switch (see
b Use six of the provided screws to secure the bracket to the switch housing.
Summit Family Hardware Installation Guide
(Figure 262: Grounding a Summit X670 Series Switch
Installing the X670 or X770 Switch in a Cabinet or Four-Post Rack
Installing Summit Family Switches
on page 281).
Installing a Versatile Interface Module in a
Switch).
on page 281).
281