Removing A Summit X650 Series Switch - Extreme Networks Summit X150 Series Hardware Installation Manual

3 Carefully slide the switch forward out of the cabinet and off the rear mounting brackets.
Figure 356: Removing the Switch from a Four-Post Rack
4 Set the switch on a secure work surface.
5 Using a #1 Phillips screwdriver, remove the front mounting brackets from the sides of the switch.
6 Remove the rear mounting brackets from the rear rack posts.

Removing a Summit X650 Series Switch

This section provides procedures for removing a Summit X650 series switch from a two-post or four-
post equipment rack.
Before you remove a Summit X650 series switch from the rack, remove all installed power supplies, as
described in one of the following sections.
Removing a Summit X650 AC Power Supply
To remove a Summit X650 AC power supply:
1 Disconnect the power cord from the wall outlet and from the power input connector on the power
supply.
2 Push the latching tab to the left as you pull the handle to disengage the power supply from its
internal connectors.
Summit Family Hardware Installation Guide
Removing a Summit Family Switch from a Rack
368