Replacing Xgm And Xgm2 Series Port Option Cards - Extreme Networks Summit X150 Series Hardware Installation Manual

4 Remove the replacement VIM from its anti-static packaging.
5 Install the replacement VIM in the switch (see
a Make sure the inserter/ejector levers are rotated down.
b Carefully slide the module into the switch until the inserter/ejector levers begin to rotate
upward.
c Simultaneously rotate both levers upward to seat the module internal connectors.
d Insert and tighten the retaining screws you removed earlier.
Figure 346: Installing a VIM
VIM2-SummitStack module

Replacing XGM and XGM2 Series Port Option Cards

This section describes how to replace XGM and XGM2 series port option cards in Summit X350, X450a,
and X450e series switches.
Caution
Pluggable optical modules may become very hot after prolonged use. Take care when
removing a pluggable optical module from the option card. If the pluggable optical module is
too hot to touch, disengage the module and allow it to cool before removing it completely.
Caution
Summit port option cards are not hot-swappable. Disconnect power to the switch before
installing or removing a Summit XGM or XGM2 series option card. After the Summit port
option card is installed in a compatible switch, you can hot-swap pluggable optical modules.
Use only optical modules approved by Extreme Networks.
To replace a port option card:
1 Disconnect the AC power and any redundant power supply from the Summit switch.
2 Attach an ESD-preventive wrist strap to your bare wrist and connect the metal end to an
appropriate ground point on the equipment rack.
3 Remove the screws that secure the option card to the switch.
a Save the screws for re-use.
4 Pull the option card out of the switch and set it on an ESD-preventive surface.
Summit Family Hardware Installation Guide
Replacing Port Option Cards and VIMs
Figure 346: Installing a VIM
VIM4-40G4X module
on page 358):
358