Installing A 750 W Ac Power Supply In A Summit X460 Series Switch - Extreme Networks Summit X150 Series Hardware Installation Manual

6 Connect the other end of the power cord to an AC power outlet.
Warning
Always be sure that the source outlet is properly grounded before plugging the AC power
cord into the AC power supply.
To install a second power supply, repeat steps 1 through 6.

Installing a 750 W AC Power Supply in a Summit X460 Series Switch

Warning
To prevent an electrical hazard, make sure that the AC power cord is not connected to the
power supply before you install the power supply in the power supply bay.
Caution
Make sure that the AC power supply circuit is not overloaded. Use proper over-current
protection, such as a circuit-breaker, to prevent over-current conditions.
To install a 750 W AC power supply in a Summit X460 series switch:
1 If necessary, remove a blank panel from the back of the Summit X460 series switch
Blank Panel).
Figure 203: Removing a Blank Panel
2 Verify that the power supply is right side up (see
3 Carefully slide the power supply all the way into the power supply bay (see
Power Supply).
Summit Family Hardware Installation Guide
Installing Summit Family Switches
Installing a 750 W AC Power
(Removing a
Supply).
Installing a 750 W AC
231