Extreme Networks Summit X150 Series Hardware Installation Manual page 230

1 If necessary, remove a blank panel from the back of the Summit X460 series switch.
Figure 201: Removing a Blank Panel
2 Verify that the power supply is right side up (see
230).
3 Carefully slide the power supply all the way into the power supply bay (see
Power Supply on page 230).
4 Push the power supply in until the latch snaps into place.
Caution
Do not slam the power supply into the switch.
Figure 202: Installing a Power Supply
Note
If power supplies are not installed in both power supply bays, be sure to install a cover
over the unoccupied bay. Unoccupied bays must always be covered to maintain proper
system ventilation and EMI levels.
5 Connect the AC power cord to the input connector on the power supply and rotate the wire clip into
place over the power cord connector.
Summit Family Hardware Installation Guide
Installing Summit Family Switches
Figure 202: Installing a Power Supply on page
Figure 202: Installing a
230