Extreme Networks Summit X150 Series Hardware Installation Manual page 312

4 Push the power supply in until the latch snaps into place.
Caution
Do not slam the power supply into the switch.
Figure 291: Installing a 750 W AC Power Supply in an EPS-C2 Chassis
Note
If power supplies are not installed in all three slots, be sure to install a cover over each
unoccupied slot. Unoccupied slots must always be covered to maintain proper system
ventilation and EMI levels.
To install each additional power supply, repeat steps 1 through 3.
Connecting Redundant Power Cables for the EPS-C2 Chassis
The EPS-C2 chassis can use the following types of redundant power connectors (See
C2 2x9 Pin Redundant Power Cable with Connector Key Tab
Pin Redundant Power Cable with Connector Key Tab
•
One 2X9-pin connector
This connector is compatible with the Summit X450e-48p or Summit X250e-48p switch.
Warning
The 2x9 cable is not hot-pluggable. Do not attach a powered EPS-C2 to any Summit
switch using the 2x9 connector.
Summit Family Hardware Installation Guide
Installing Summit External Power Supplies
on page 313 and Figure 293: EPS-C2 2x7
on page 313):
Figure 292: EPS-
312