Installing A Summit X460 Series Switch - Extreme Networks Summit X150 Series Hardware Installation Manual

1 Plug the DC wiring harness connector into the DC power supply socket on the rear of the switch
(see the figure below).
The pins must align properly for the cable to completely connect. Do not force the cable into the
socket until the keyway is aligned properly. Refer to
306 for the DC wiring harness connector.
Figure 191: DC Power Socket on a Summit X450a Series DC-Powered Switch
Note
The figure above shows the rear panel of a Summit X450a series DC-powered switch. The
rear panel of other Summit DC-powered switches may vary slightly; however, the DC
power socket is of the same type and the connection process is the same for all DC-
powered switches.
2 Tighten the retainer nut on the connector until it is finger-tight.
3 Energize the DC circuit.

Installing a Summit X460 Series Switch

The Summit X460 series switch fits into a standard 19-inch equipment rack.
The provided rack- mounting brackets attach to the front of the switch unit and are adaptable to either
a front-mount or mid-mount installation.
The installation process includes the following tasks:
1 Install the switch in the rack.
2 Install the first power supply.
3 (Optional) Install a second power supply.
4 (Optional) Install a port option card or stacking module, or both.
5 Connect power cables.
6 For a stacked configuration, connect stacking cables
7 Connect network interface cables.
If you are installing Summit X460 series switches for use in a SummitStack configuration, read
Family Switches before you install the switches.
Note
Take care to load the rack so that it is not top-heavy. Start installing equipment at the bottom
of the rack and work up.
Summit Family Hardware Installation Guide
Installing Summit Family Switches
Figure 283: Three-wire Cable Harness on page
Summit
220