Extreme Networks Summit X150 Series Hardware Installation Manual page 205

a Holding the cable connector with the release tab on top, align the connector with the stacking
port on the VIM2 module in the Summit X480 series switch.
Figure 178: Connecting the 64G Connector
b Firmly press the cable connector into the stacking port until the spring latch on top of the
connector clicks into place.
2 Connect the 20G connector as follows:
a Align the cable connector with the stacking port connector on the back of the switch (see
179: Connecting the 20G Connector
b Firmly press the cable connector into place on the mating stacking port connector.
c Align and tighten the retaining screws on the cable connector.
Figure 179: Connecting the 20G Connector
Connect Active or Passive QSFP+ Cables
The QSFP+ direct-attach cable is used to connect ports on either of the following modules:
Summit Family Hardware Installation Guide
on page 205).
Building Stacks
Figure
205