Extreme Networks Summit X150 Series Hardware Installation Manual page 253

2 If you are installing the power supply in a Summit X670 series switch:
a Verify that the switch chassis has been grounded (see step
b Verify that the airflow direction for the power supply is the same as the airflow direction of the
installed fan modules in the switch.
3 If necessary, remove a blank panel from the back of the Summit X480 or X670 series switch.
Figure 230: Removing a Blank Panel
4 Verify that the power supply is right side up, with the latching tab at the left of the unit (see
231: Installing a Power Supply
5 Carefully slide the power supply all the way into the power supply bay (see
Power Supply on page 253).
6 Push the power supply in until the latch snaps into place.
Caution
Do not slam the power supply into the switch.
Figure 231: Installing a Power Supply
Summit Family Hardware Installation Guide
on page 253).
Installing Summit Family Switches
6 on page 279 ).
Figure 231: Installing a
Figure
253