Management Port Cabling; Stacking Port Leds; Stack Number Indicator Leds - Extreme Networks Summit X150 Series Hardware Installation Manual

Management Port Cabling

Connect the master, backup, and all other master-capable switches to your management network
using the Ethernet management port on the rear panel of each switch.
If you choose the default redundancy setup, only slots 1 and 2 are allowed to become master. You may
connect all switch management ports in the stack if you choose to do so. There is an alternate IP
address configuration that will allow you to directly log into an individual switch in the stack through its
management port.

Stacking Port LEDs

Each stacking port has an LED. The LED is steady green if the link is OK, blinking green if traffic is
present, and off if no signal is present.

Stack Number Indicator LEDs

The Stack Number Indicator LED shows the slot number of the switch in the stack.
The top half of the number blinks if the switch is the master, and the bottom half blinks if it is the
backup. If the LED is steadily lit, the switch is a standby. If the LED is off the switch is not configured as
a member of a stack.
Summit Family Hardware Installation Guide
Building Stacks
207