Extreme Networks Summit X150 Series Hardware Installation Manual page 263

3 From the back of the equipment rack, slide the switch into place over the mounting brackets.
Make sure the brackets slide between the support pegs on both sides of the switch.
Figure 240: Sliding the Switch onto the Rear Mounting Brackets
4 Push the switch forward as far as it will go, until the bracket support pegs are against the T of the
mounting bracket (see
263).
a Securely tighten the rack mounting screws.
Figure 241: Fastening the Rear Mounting Brackets—Two-Post Rack
Summit Family Hardware Installation Guide
Figure 241: Fastening the Rear Mounting Brackets—Two-Post Rack
Installing Summit Family Switches
on page
263