Installing A Port Option Card In The 8500-Msm24, 8800-Msm48C, 8800-Msm96, Or 8900-Msm128 - Extreme Networks BlackDiamond 8800 Hardware Install Manual

Installing a Port Option Card in the 8500-MSM24, 8800-MSM48c,
8800-MSM96, or 8900-MSM128
The 8500-MSM24, 8800-MSM48c. 8800-MSM96, and 8900-MSM128 modules each have a slot for one
of the following port option cards:
•
S-G8Xc, which adds eight 1-gigabit SFP data ports to the MSM
•
S-10G1Xc, which adds one 10-gigabit XFP data port to the MSM
•
S-10G2Xc, which adds two 10-gigabit SFP+ data ports to the MSM
You need the following tools and equipment to install a port option card:
•
ESD-preventive wrist strap
•
#2 Phillips screwdriver
•
#1 Phillips screwdriver
•
3/8-inch straight-tip screwdriver
Caution
Port option cards for the 8500-MSM24, 8800-MSM48c and 8900-MSM128 are not hot-
pluggable. You must administratively disable the module and remove it from the switch
before you install the port option card
To install a port option card in an MSM:
1 Attach the ESD-preventive wrist strap to your bare wrist and connect the metal end to the ground
receptacle on the top-left corner of the switch chassis.
2 Remove the MSM from the switch as described in
on page 95.
3 Loosen the retaining screws on the option slot cover plate
plate.
Figure 77: Option Slot Cover Plate
4 Align the port option card with the card guides on the module, and carefully slide the card into the
option slot.
BlackDiamond 8800 Hardware Install Guide
Installing BlackDiamond 8800 Series Module Options
Removing a BlackDiamond 8000 Series Module
(see the following figure) and remove the
106