Extreme Networks Summit X150 Series Hardware Installation Manual page 195

•
Summit X250e, X440, X450, X450a, and X450e series switches with integrated SummitStack ports
•
Summit X480 series switches with installed VIM2-SummitStack modules
•
Summit X650 switches with installed VIM1-SummitStack modules
To connect a Summit Stack 40G stacking cable:
1 Align the cable connector with the stacking port connector on the back of the first switch (see
Figure 165: Connecting a Summit Stacking Cable
2 Firmly press the cable connector into place on the mating stacking port connector.
3 Align and tighten the retaining screws on the cable connector.
4 Repeat steps 1 through 3 to connect the cable to the second switch.
Figure 165: Connecting a Summit Stacking Cable
Caution
Avoid making sharp bends in the cable. Sharp bends can stress the cable and cause
damage.
Connect a SummitStack 128G Cable
Because of the weight of the SummitStack 128G cable, Extreme Networks strongly recommends the
use of cable management hardware to support the cables and provide strain relief at the connectors.
Figure 166: Cable Management Using a J-Shaped Support Bracket
Management Using Tie-Wraps and a Stand-Off
management hardware. Your particular rack configuration may require other cable management
solutions.
Summit Family Hardware Installation Guide
on page 195).
on page 196 and
on page 196 show representative types of cable
Building Stacks
Figure 167: Cable
195