Extreme Networks Summit X150 Series Hardware Installation Manual page 197

1 On the side of the connector nearest to the inserter/ejector lever, find the notch between the two
end tabs on the cover (see
2 At the notch, set a small flat-blade screwdriver firmly against the connector housing.
Figure 168: Removing a Connector Cover
3 Brace the screwdriver against the module inserter/ejector lever and pry the end of the connector
cover loose.
4 Slide the cover off the connector.
Note
Store the connector covers for later re-use if the switch will be operated without
connecting these ports.
Caution
To ensure satisfactory protection from EMI, leave the covers on all ports that are not
connected to another VIM1-SummitStack512 module.
Connect the Cable
To connect a SummitStack 128G cable:
Summit Family Hardware Installation Guide
Figure 168: Removing a Connector Cover
Building Stacks
on page 197).
197