Extreme Networks Summit X150 Series Hardware Installation Manual page 335

3 Disconnect the ground wire as follows:
a Remove the screw that secures the ground wire to the power supply.
b Move the wire away from the power supply.
4 Push the latching tab to the left as you pull outward on the handle to disengage the power supply
internal connectors (see the figures below).
Figure 318: Removing a Summit 300 W
DC Power Supply (Model 10934A)
5 Carefully slide the power supply the rest of the way out of the switch.
Install the Replacement Power Supply
To install a replacement Summit 300 W DC power supply:
1 Verify that the power supply is right side up. See
Supply (Model 10934A)
(Model 10933) on page 336.
2 Carefully slide the power supply all the way into the power supply bay. See
Summit 300 W DC Power Supply (Model 10934A)
300 W DC Power Supply (Model 10933)
3 Push the power supply in until the latch snaps into place.
Caution
Do not slam the power supply into the switch.
Summit Family Hardware Installation Guide
Replacing DC Power Supplies in Summit Family Switches
Figure 320: Installing a Summit 300 W DC Power
on page 336 and Figure 321: Installing a Summit 300 W DC Power Supply
on page 336.
Figure 319: Removing a Summit 300 W
DC Power Supply (Model 10933)
Figure 320: Installing a
on page 336 and Figure 321: Installing a Summit
335