Toshiba Strata DK 280 Installation Manual page 763

Automatic Number
Identification (ANI) and
Caller ID calls:
ANI Example
If your telephone has bee" programmed with ANI capability, you may:
n Activate ANI and/or Caller ID display mode by pressing MODE + 6 I.
(System default is ON.)
n Deactivate ANI and/or Caller ID display mode by pressing MODE + 6 0.
Note:
ANI information cannot co-exist on the fame telephone LCD with Dialed
Number identification Service (ON/S) information. (See ON/S.) if your
system is programmed to receive both AN/ and DNIS information on
incoming calls. then when an ANVDNIS call is ringing, press PAGE to
alternate between /IN/S and AN/ LCD displays.
If your telephone has bee" programmed with ANI capability and you have
activated the ANI display feature, the calling party's telephone number (up to 10
digits) will be displayed when the call arrives at your stabon.
Notes:
1. The fobwing examples show AN/. If Caller ID was activefed, then
the caller's name or number would appear on fhe first line.
2. If CN: is displayed, the calling number is an (AN/) number; CN: does
not precede Caller /D numbers.
When you answer the incoming call. After you answer a call, call duration will
display on LCD.
When you place the call on hold
Held call automatically recalls your station after a programmed period of time.
The display changes to indicate calling status
Station 201 is transferring a" ANI (or Caller ID) call to you (station 200). For the
purpose of demonstration, following screens depict different displays of your
station.
6
Caller ID Example
Auto Busy Redial (ABR):
[::R:::j
Automatic Callback (ACE):
(In,]
After the transferring station (station 201) hangs up.
When you an.swer the transferred call.
If you do not answer the transferred call within a programmed period of time, the
held call will automatically recall the transferring station (i.e., station 201). This
screen shows the display of the transferring station (i.e., station 201) as the call
recalls.
If your telephone is programmed with Caller ID capability and you have activated
the Caller ID display feature, the telephone "umber (up to 10 digits) or name (up
to 15 characters) of the calling party will be displayed when the call arrives at
your station.
After setting Auto Busy Redial. your display prompts you that it has been set.
When the system dials the call, your display shows the dialed number. The
system inserts a pause (P) before redialing the number.
When the called telephone is ringing, your station's CO Line LED (or [DN] LED)
and SPKR LED will flash, and a warning beep will sound 30 seconds after the
call is completed. You must go off-hook or press SPKR to prevent
disconnection.
When you set Automatic Callback at a busy station, its number is displayed.
When you receive a" automatic callback. the station number you called is
displayed.
When you set ACS at a busy line group, its axe?& code "umber is displayed.
-
7