Speed Dial; Storing Station Speed Dial Numbers - Toshiba Strata DK 280 Installation Manual

c
To Store a Station Speed
Dial Number:
1. Do not lift the handset.
2. press RDI. or #.
3. Press the SD button
you wish to store the
telephone number on.
press SDS or + and
enter the code that you
want to store the
telephone number in.
4. Enter the telephone
number.
Speed Dial
Speed Dial enables you to call a telephone number with a brief access code or
an optional feature button. There are two types of Speed Dial numbers:
n Station Speed Dial numbers are assigned by individual station users to
their own station and can only be dialed at their station.
W System Speed Dial numbers can only be assigned from station 200
(typically the operator's or System Administrator's telephone), but can be
used by other stations.
Your station will time out to the idle mode if the following storage procedures are
not completed within one or three minutes. The time is set in system
programming.
Storing Station Speed Dial Numbers
You can store personal telephone numbers on either Station Speed Dial buttons
or access codes. You can call the telephone number by either pressing the
button or dialing the access code.
SD buttons are assigned in system programming.
If your telephone does not have a" SDS button, enter * or access codes
instead. Station Speed Dial number codes are 1 0 - 4 9.
You can enter up to 20 digits.
Notes:
1. To store longer dialing strings, see Chapter 3-Advanced
Features-Speed Dial Number Linkina for instructions on storino
additional dibits.
2. To insert a pause or f/ash signal in the number, see Chapter
3--Advanced Features-Speed Dial Pause and Flash Storage.
5. Press RDL or #.
To Store a System Speed
Dial Number
at Station ZOO:
1. Do not lift the handset.
2. Press RDL or #.
3. Press SDS or i.
4. Enter the Speed Dial
code
that you want to store
the telephone number
in.
5. Enter the telephone
number.
6. Press RDL or #.
To Clear a Speed Dial Entry:
l Repeat the preceding
procedure, skipping
step 4.
3. To store [DN] button access, followed by a CO line access code
before the telephone number to allow one-touch dialing of telephons
numbers, see Appendix A-Tab/e 4-&w Programmable Access
Codes.
The number will be stored and will be dialed when SD is pressed, or when SDS
is pressed followed by the Speed Dial access code.
Repeat this procedure to replace stored telephone numbers with new ones. To
clear a Speed Dial ently. repeat this procedure, skipping Step 4.
Storing System Speed Dial Numbers
Only attendant consoles and station 200 (typically the System Administrator's
phone) can store System Speed Dial numbers, although they are available to all
stations for dialing. System Speed Dial buttons can be assigned lo station
flexible buttons in system programming.
Station 200 is the station that has Directory Number 200 as its [PDN].
System Speed Dial number codes are 6 0 0 - 6 9 9 or 6 0 - 9 9.
Note:
Some telephone system models provide 100 Speed Dial codes (6 0 0 -
6 9 9) and others provide 40 codes (6 0 - 9 9).
You can enter up to 20 digits. See Notes in previous section, "Storing Station
Speed Dial Numbers."
The number will be stored and will be dialed when the Speed Dial code is
entered at a station, or when an SD button associated with the code is pressed.
Repeat this procedure to replace the stored telephone numbers with new ones.
38
39