Toshiba Strata DK 280 Installation Manual page 354

Table 8-7
Program 03- Flexible PCB Slot Assignments
Press...
Step
Buttons
+ LED
buttons
3.
Action description LCD RESPONSE . . .
1.
Use the programming LCD electronic or digital teiephone
NO. 205
with programming template connected to physical port 005
JAN 20 SUN
06:43
(station 205) - circuit 6.
2. *#*#1*2*3
PROGRAM MODE
Enter programming mode. (Do not press Intercom or [DN]
button.)
3. Spkr (Speaker) 0 3 Hold
PROGRAM = 03
Access Program 03. After pressing Spkr (Speaker) button
DATA STORE
the system beeps to indicate program number may be entered.
4. Spkr (Speaker)
03 SELECT =
Prepare system for a selection.
5. Dial a PCB slot number (00-66) using the dial. 03 SELECT = (00 - 66)
CARD= (91, 62 or b0)
The system defaults as follows:
00
03 SELECT = 00
Initialized data assigns slot 00 and 01 to be a
CARD = 91
-SLOT NUMBER
non-optioned RCTU without RRCS DTMF receivers.
11
03 SELECT = 11
Initialized data assigns slot 11 to be a non-optioned
CARD=62
=SLOT NUMBER
PDKU without DSS console or OCA.
12-66
03 SELECT = (12 - 66)
Initialized data assigns slots 12 - 66 to be empty. CARD = 00
LOT NUMBER
6. 00-9s
03 SELECT = (00 - 66)
Dial the PCB code recorded on the record sheet.
CARD = (00 -
97)
Refer to the PCB code reference table on Program 03
System Record Sheet for a definition of the codes.
7. Hold
03 SELECT = (00 - 66)
Secure data in system programming.
DATA PROGRAMMED
a. Spkr (Speaker)
03 SELECT =
Prepare system for another selection (go back to
Step 5), or exit Program 03 (continue with Step 9).
9.
# # Hold
03 SELECT = ##
Secure Program 03 data in system memory.
DATA PROGRAMMED
0.
Spkr (Speaker)
PROGRAM =
Exit Program 03. Enter another program number (see
Table 8-54, or exit programming mode (go to Step 11).
System beeps to indicate it is exiting Program 03.
1: ##Hold
NO. 205
Exit programming mode.
JAN 20 SUN
06:58
2.
To secure Program 03 entries, Power OFF for five seconds,
then Power ON.
8-l 4
January
1996