Toshiba Strata DK 280 Installation Manual page 724

c
To Place a Call on Exclusive
Hold:
l While on an outside
call, press HOLD
twice.
To Retrieve a Call on
Exclusive Hold
N Press the CO button
that is on Exclusive
Hold
To Park a Call:
1. While on a CO line call
or an internal call,
press PARK
-or-
CONFrCRNS t
#332.
Exclusive Hold
Exclusive Hold allows you to place a call on hold so that only you or somebody
using a Call Pickup code at another station can retrieve it.
After you press HOLD the second time, the Line LED will flash at the exclusive
hold rate.
Another station user can pick up the call by dialing # 5 plus your station number,
or by dialing # 5 # 7 plus the CO line number (0 0 1 - 14 4) that the call is held
0".
Call Park Orbits
The Call Park feature allows you to hold a call temporarily in an orbit and then
anyone can retrieve the call from the orbit with the same station or with a
different station. Orbits are the areas where calls are held. There are 20 General
Park Orbits for the system and one Personal Park Orbit for each station. Once
you have parked a call in an orbit, you can:
w Hang up and retrieve the parked call at a later time.
H Originate another call.
n Access a voice paging device to announce the parked call for pickup from
another station.
If you park a call and your station is idle while the system Call Park recall timer
expires, the parked call will automatically recall to your station; if your station is
busy, the parked call will camp-on to your station. The CO or [DN] LED will flash
at the consultation-hold rate until you enter the orbit number.
24
2. Enter a General Orbit
Number f9 0 0 -
919)
or
enter a valid [PDN].
3. Hang up.
To Pick Up or Retrieve a
Parked Call:
1. Press the parked CO 01
[DN] button. or press
PARK
press CONFlTRN5 +
#332.
2. Enter the Orbit Number
or valid [PDN] at which
the call is parked.
To Park a Call and Page:
1. While on a CO line call
or an internal call,
CPIPG.
2. Enter a General Orbit
Number (9 0 0 -9 19)
or a valid [DN].
3. Enter the Paging
acces.~ code-
4. Make your
announcement
5. Hang up to free the
paging device.
After dialing the orbit number, you will hear a short dial tone and the call will be
parked and the CO line will flash at the Hold rate, or the [DN] LED will go out.
The CO Line LED will flash at an on-hold rate (the [DN] LED will be off). The call
is parked at the orbit with the orbit number that you have just entered.
The Orbit Number is usually provided in the paging announcement. The CO Line
or [DN] LED will flash at the In-use rate when the call is picked up or retrieved.
Call Park and Page
The CO Line or [DN] LED will flash at the consultation-hold rate.
The CO Line will flash at an on-hold rate (the [DN] LED will be off). You will hear
a short dial tone for your paging access.
See Appendix A-Table 2. Paging Group Codes and Paging Zone Codes.
Remember to include the Orbit Number in your announcement,
The paging device will not be released until you hang up.
25