Rctuba Controls, Indicators, And Interface Connectors (Release 3) - Toshiba Strata DK 280 Installation Manual

Table 4-8

RCTUBA Controls, Indicators, and Interface Connectors (Release 3)

RCTUBA Ribbon Cable Connector P2
DTMF Receiver Connector P3
DTMF Receiver Connector P4
DTMF Receiver Connector P5
DTMF Receiver Connector P6
BATT Battery Jumper P9
RCTUBA Ribbon Cable Connector P11
Volume Control VRl
RRCS
CONNECTORS-
RRCS
CONNECTORS.
Figure 4-1
1
RCTUBA Controls, Indicators, and Interface Connectors (Release 3)
January 1996
Connector and
ribbon cable
10-pin male connector
6-pin male connector
1 0-pin male connector
6-pin male connector
3-terminal jumper
RCA jack
Connector and
ribbon cable
Trim Dotentiometer
. . . .
. . . . . .
P6
TO RCTUBBlRSlS
CONNECTORS
TO RCTUBB (AND RSlU IF INSTALLED, SEE FIGURE 4-39 FOR RSlU INSTALLATION)
Description
Ribbon cable connector for connection to
RCTUBB. Used in conjunction with P2.
Interface connector for optional DTMF
Receiver subassembly (RRCS).
Used in conjunction with P4, P5, and P6.
Interface connector for optional DTMF
Receiver subassembly (RRCS).
Used in conjunction with P3, P5, and P6.
Interface connector for optional DTMF
Receiver subassembly (RRCS).
Used in conjunction with P3, P4, and P6.
Interface connector for optional DTMF
Receiver subassembly (RRCS).
Used in conjunction with P3, P4, and P5.
Interface connector for on-board lithium
battery that protects configuration data
stored in system RAM.
Interface connector for MOH/BGM source.
Ribbon cable connector for RCTUBA and
RSIU. Used in conjunction with P2.
Adiusts volume for MOH/BGM source.
connected to RCTUBA.
CONNECTOR
0
INSTALL IN
SLOT
PLACE BATERY
JUMPER TO ON
POSITION BEFORE
INSTALLING PCB
(RCA JACK)
4-1 5