Rctuc3 Controls, Indicators, And Interface Connectors (For Release 3) - Toshiba Strata DK 280 Installation Manual

Table 4-1 0
RCTUC Ribbon Cable Connector P2
DTMF Receiver Connector P3
DTMF Receiver Connector
DTMF Receiver Connector P5
DTMF Receiver Connector P6
I
RCTUC Ribbon Cable Connector P11
I
Volume Control
RRCS
CONNECTORS.
RRCS
CONNECTORS
Figure 4-1 3
Controls, Indicators, and Interface Connectors (for Release 3)
1996
January
Type of
Component
Connector and
ribbon cable
1 0-pin male connector
6-pin male connector
P4
1 0-pin male connector
6-pin male connector
3-terminal jumper
RCA jack
Connector and
ribbon cable
Trim potentiometer
PROGRAM
ROM
CONNECTORS
Description
Ribbon cable connector for connection to
RCTUD. Used in conjunction with P2.
Interface connector for optional DTMF
Receiver subassembly (RRCS).
Used in conjunction with P4, P5,
Interface connector for optional DTMF
Receiver subassembly (RRCS).
Used in conjunction with P3,
Interface connector for optional DTMF
Receiver subassembly (RRCS).
Used in conjunction with P3,
Receiver subassembly (RRCS).
Interface connector for on-board lithium
battery that protects configuration data
stored in svstem RAM.
Interface connector for MOH/BGM source.
Ribbon cable connector for RCTUD and
RSIU. Used in coniunction with P2.
Adjusts volume for MOH/BGM source
connected
to RCTUC.
INSTALL IN SLOT "R11"
(SCREWDRIVER ADJUSTMENT)
and P6.
and P6.
P4, and P6.
4-1 7