Toshiba Strata DK 280 Installation Manual page 345

Minimum Software Requirements
To prepare the system software for programming,
clear the memory by initializing its data (with Program
91-g), as specified in Section 8.4-General
Programming Guidelines. Next, after installing all of
the PCBs, Program 91-1 or 91-9 must be run to inform
the software of the system's hardware configuration.
After running Program 91-l or 91-9, run Program .03
for all PCBs that have options. Basic system
programming can then begin.
8.4 General Programming Guidelines
The following is a general procedure for programming
the system.
1. Run Program 91-9 twice in succession to initialize
the system. All PCBs may or may not be installed
- it does not matter.
CAUTION !
Program 91-9 will erase all program data and
will drop a// calls if it is run while the system is
in service.
Program 91-9 sets the following elements to initial
status:
+ Data for Programs 00 - *99
+ Speed Dial Memory
+ Voice Mail Identification Codes
+ Character Message Memory
+ Timed Reminders
+ Digital Telephone Volume Levels
+ Call Forward Memory (Power OFF, then ON).
2. After installing all PCBs, run Program 91-1 to
inform the software of the system hardware
configuration.
8.4.1 After Initialization
Immediately after initializing the system with Program
91-9 and 91-1:
1. Run Programs 03 and 19-1 to inform the software
of the system option hardware configuration (see
Table 8-7, and the Program 19 record sheet)
2. Run Program 00 to assign remote maintenance
security codes (see Table 8-8). With Strata DK280
Release 3 and above, anytime after initialization,
the RCTU processor PCB RAM can be tested
using Program 00. The RCTU RAM test procedure
is provided on the Program 00-Part 2 record sheet
in Chapter 10 -Record Sheets.
3. Run additional programs as required. .
All programs are entered from the LCD digital or
electronic telephone connected to physical Port
005
or, they are uploaded using 280Admin or 280Backup.
If uploading with 280Admin or 280Backup, you must
download Program 03 first to set the correct PCB slot
code data in the 280Admin or 280Backup database.
The time and date can be set anytime after
initialization. This is not accomplished from the
programming station, but rather from the digital or
electronic telephone connected to logical Port 000
(usually station number 200).
Refer to Figures 8-3 for the date, 8-4 for the system
time, and 8-5 for the day. of the week (Monday,
Tuesday, etc.). Program 91-9 does not initialize time
and date.
January 1996
8-5