Dk280 Alarm Sensor Installation; 6.11 Auto Attendant - Toshiba Strata DK 280 Installation Manual

n Take the DKT's handset off-hook at any time after
the telephone number is dialed and press the
Spacebar to release the Data Call button; or,
remain on-hook and use the DKT's speakerphone.
Note:
Speakerphone model only: pressing the
Spacebar
when using the speakerphone
feature disconnects the call.
H To terminate the call anytime:
A. If off-hook, press the Spacebar and place the
DKT handset on-hook.
6. If talking via the speakerphone, press the
Spacebar.
6.10 DK280 Alarm Sensor Installation
The PIOU or PIOUS PCB provides a circuit that can
be set to detect a relay open or closed condition from
a facility alarm system. When the sensor is activated,
all electronic and digital telephones will sound an
alarm signal. The electronic/digital telephone alarm
signal can be reset by any electronic or digital
telephone with an alarm reset button (see
Program 39).
Alarm Sensor Options
Jumper plug P12 on the PIOU is used to set the alarm
sensor to detect an open or closed condition from the
facility alarm system. Set P12 as follows (refer to
Figure 6-40):
PIOU PCB
PIOU PIN
NUMBERS ( )
II 25-PAIR CABLE ,
1 To detect a closed condition, set P12 to the N.O.
position.
4 To detect an open condition, set P12 to the N.C.
position.
Jumper W3 on the PIOUS is used to set the alarm
sensor to detect an open or closed condition from the
facility alarm system. Solder the W3 jumper wire as
follows (refer to Figure 6-40):
H To detect a closed condition, solder W3 to the
normal open position.
n To detect an open condition, solder W3 to the
normal closed position.
Alarm Sensor Wiring
Refer to Figure 6-40, and connect the facility alarm
system relay contacts to the PIOU/PIOUS PCB.
6.11 Auto Attendant
Auto Attendant operates like an automatic station
attendant or switchboard operator that quickly and
efficiently distributes calls to stations selected by
callers. Incoming calls are greeted by an external
announcement device that offers callers a menu of
station locations associated with a number, such as 3
for Sales, 4 for Customer Service, etc. Callers pick the
destination just by dialing the single number
associated with it. The call is then transferred to the
66 BLOCK PIN NUMBERS
E/n
N.C.
II
ALMT (36)
21
PI2 .
ALARM
J FACILITY
:
SENSOR
ALMR (11)
. 22
( ALARM
N.O. /
SYSTEM
25-PAIR CABLE
PIOUS PCB
I
NORMeL OPEN
I
DK0342
Figure 6-40
DK280 Alarm Sensor Block Diagram (PIOU/PIOUS)
1
FACILITY
1
ALARM
SYSTEM
January 1996 6-61