Toshiba Strata DK 280 Installation Manual page 699

Table 13-26
CO line Test
step Action Display/Printout
1 Enter the Test Mode
>MODE TEST
At the
XMODE
prompt, type TEST, press Enter.
2
To Verify Station/CO Line Status
T SEKT XXX IDLE ON-HOOK
Station line status, type SEKTXXX (X X X = CO line number).
T
CO line status, typeBcoYYY (YYY = CO line number).
T SC0 YYY IDLE
3
Call Remote Station B (from SEKT XXX and CO line YYY)
T TK XXX KY-YY ~~~fl~~~
Type
TKXXXK YYY nnnnnnrj, press Enter. T
(n= station B's telephone number)
Answer station B.
General Note:
. If the system is equipped with Music-on-Hold, go to Step 4. If
the line must be tested via a CO-to-CO connection, go to
Step 6.
4
A. Press the Hold button on TKXXX (station B on hold).
TTKXXXH
Type T-,
press Enter.
T
B. Listen at station B and check that the transmission from the
music source is acceptable.
C. Press the Spkr (SPEAKER) button on TKXXX (to release the
T TKXXX S
call).Type TKXXXS, press Enter.
T
5 Continue returning to Step 2 until all CO lines are tested.
6
To Set Up A CO-to-CO Connection
TTKXXC
Press the Cnf/Trn (CONF/TRNS) button on
TRXXX.
T
Type TKXXXC, press Enter.
General Notes:
l
Station B is connected via Step 3.
l
VeriQ that Program 15-5 allows CO-to-CO connections.
l
The next step must be completed immediately to avoid
dial tone timeout.
7
Call Station C (or local time/weather) via CO line C.
T TKXX K=~~~~~tlfl
Type: TKXXICYYY nnnnnnn,ptX?SS Enter. T
xx = CO line C's key number and 0 = telephone number of
Station C.
Answer Station C (or verity time/weather connection) and go to
next step.
8
Press the Cnf/l'rn (CONF/TRNS) button on STXX to establish a
TTKXXC
conference between all parties.
T
9 If you wish to tie the two CO lines together and hang up:
T TKXX C
Type T-C, press Enter. TTKXX S
Type TKXXS, press Enter.
T
IO
Continue returning to Step 2 until all CO lines are tested.
11 To Exit the Test Mode,
At the
T
prompt, type QUIT, press Enter.
DKo4
13-36
January 1996