Rkys Feature Key Installation - Toshiba Strata DK 280 Installation Manual

The VRI potentiometer does not control the volume of
alternate BGM sources connected to either the RSTU,
RDSU, PSTU, PEKU, PESU, or other BGM source
interfaces.
Install the MOH/BGM source to the common control
unit per instructions in Chapter 6- Peripheral
Installation. Adjust the V R I potentiometer to'the
desired volume level while listening to MOH or BGM.
RCTUA (1 3), RCTUB (1
or
Installation
The RCTUA, and the RCTUB can be equipped with a
RRCS-4, RRCS-8, or RRCS-12. Install the RRCS (4,
8, or 12) on the RCTUA, RCTUB or in accordance
with the following steps:
or
or
or
ONLY
RCTU
D
RCTU A, B, BB, or D
Figure 4-3
RKYS
Feature Key Installation
RRCS
or 2)
above
and above
TOSHIBA
or
Remove the RCTUA (1 or 3) or RCTUB (1 or 2)
from its protective packaging. Remove the RRCS
from its protective packaging.
Note:
The RRCS connectors on the RCTUA,
P2, P3, P4, and P5. The connectors are
positioned to allow installation of the RRCS
only in the proper position.
2. Mate RRCS connectors J1, J2, J3, and J4 (Figure
4-2) with RCUTA or RCTUB connectors P2, P3,
P4, P5. (The connectors on each of the three
RRCS versions are labeled J1, J2, J3, and J4.)
3. Apply firm, even pressure to the RRCS to ensure
of
proper mating the connectors.
BACKPLANE
CONNECTOR
A
(Soldered on RC
port, Caller ID, for ACD calls
4-5