Toshiba Strata DK 280 Installation Manual page 353

Table 8-6
Initialization Program 92 - Initializing Speed Dial Numbers, VM ID Codes, Character Message Memory, Timed
Reminders, Digital Telephone Volume, and Call Forward Backup Memory
Press...
Step Buttons + LED buttons
No. Action description
LCD RESPONSE _..
1.
Use the programming LCD electronic or digital, telephone
with programming template connected to physical
NO. 205
JAN 20 SUN
port 005 (station 205) - circuit 6.
06:43
+#+#1*2*3
Enter programming mode. (Do not press Intercom or [DN]
button.) System beeps after Spkr (Speaker) is pressed to
indicate when to enter program number.
Spkr (Speaker) 9 2 Hold
Access Program 92.
Spkr (Speaker)
Prepare system for selection of programs to initialize.
For new system installation perform all 1 - 4.
PROGRAM MODE
PROGRAM = 92
DATA STORE
92 SELECT =
5.
Select one of the following.
I+ LED buttons 01 & 03
Clears Station Speed Dial, Voice Mail ID codes, and LCD
memos assigned to station speed dial numbers.
-or-
2 + LED buttons 01 & 04
Clears System Speed Dial and LCD memos assigned to
system speed dial numbers.
-or-
3 + LED buttons 02 & 03
Clears Character Message Memory (station and system)
and user name display.
- or -
4 + LED buttons 02 & 04
Clears timed reminders.
- or -
5 + LED buttons 01 & 05
Presets the Ring, Speaker, Mute Ring, and Intercom
Tone, BGM, volume levels of all digital telephones
to approximately midrange.
- or -
9 + LED buttons 03 & 04
Clears Call Forward and Message Waiting (R3) Memory
except Fixed Call Forward Memory.
Hold
Secure data in system programming. Repeat steps 4 - 6
until Step is completed (see Note 1).
Spkr (Speaker)
Prepare system for another selection (go back to
Step 5), or exit Program 92 (continue with Step 8).
92 SELECT = 1
EACH DIAL CLR
92 SELECT = 2
COMMON DIAL CLR
92 SELECT = 3
MSG CLR
92 SELECT = 4
TMR REMINDER CLR
92 SELECT = 5
DXT VR INITIAL
92 SELECT = 9
BACK UP RAM CLR
6.
7.
92 SELECT = (1-O)
DATA
PROGRAMMED
92 SELECT =
8. # # Hold
92 SELECT = ##
Secure Program 92 data in system memory.
DATA PROGRAMMED
9.
Spkr (Speaker)
PROGRAM =
Exit Program 92. Enter another program number (see
Table 8-3), or exit programming mode (go to step 10).
System beeps to indicate it is exiting Program 92.
10.
# # Hold
NO. 205
Exit programming mode.
JAN 20 SUN'
06:58
Note:
DK0052
1. If the call forward memory was cleared, cycle system power after Step 6, if it is required to reset LCD
Telephone Call Forward displays or Call Forward button LED indications.
January 1996
8-13