Toshiba Strata DK 280 Installation Manual page 383

Digital business telephone system
Hide thumbs Also See for Strata DK 280:
Table of Contents

Advertisement

n
Handsfree
Disabled,
LED
01-It
is possible to
disable the internal call Handsfree
Answer Back
function on any digital or electronic telephone.
Program
*31-Group
Pickup Assignments
Stations
can be divided
into as many as 20 pickup
groups. Station users can pick up calls that are ringing
any station
within
their group
by dialing
a single
access code (or with a Pickup button assigned
with
Code 480 in Program 39), and pick up calls that are
ringing stations
in other groups
by dialing
selected
access codes. Stations can belong to more than one
group. (See Program 05 for access codes.)
Program
32-Automatic
Preference
Automatic
Preference
for digital
or electronic
telephones
(see Note 2) via handset
off-hook
or the
Speaker
button is the automatic
connection
to lines,
the intercom,
or the Primary Directory
Number
of a
telephone
under various conditions.
With Ringing Line
Preference,
a digital or electronic
telephone
user by
going off-hook
(or by pressing the
Speaker
button)
may be automatically
connected
to the lowest line
ringing in without having to press a CO line button or
dial an access code. If no lines are ringing and an
electronic
or digital
telephone
goes off-hook,
the
station
can be automatically
connected
to the
Intercom,
[PDN],
or to a line. The line connected
can
be the lowest
numbered
line available
on the
telephone
or the highest
idle line from a selected
group.
Notes:
1.
This program
does not apply to standard
telephones.
To allow system features
to
be accessed, standard telephones
always
receive
system
internal
dial tone when
originating calls.
2.
Initialized
data assigns
Ringing
Code 1
and Automatic
Off-hook
Code 00 for all
ports.
3.
If ringing line preference
is not selected,
no auto preference
selection
will occur
when a station goes off hook during an
incoming ring condition.
Program
*32-RS-232
(SMDI
or Toshiba
Proprietary)
Voice Mail Message Center
Port
When using SMDI voice mail integration,
the Voice
Mail Port Message Center must be assigned for each
station.
The voice mail port assigned
will be called
when the station
user presses
the telephone
MSG
button after the MSG LED has been set (flashing) by
the voice mail machine. The Message
Center port is
normally the first voice mail standard telephone
port in
the Program
31 Voice Mail Group and the Program
*40 Voice Mail Distributed
Hunt Group. It is normally
the same port for all stations.
Program
33-Station
Intercom
and Directory
Number
[DN]
Hunting
(Voice Calls Only)
If a station is busy, Station Hunting allows the ringing
of an alternate station
[PDN]
or
[PhDN]
as defined by
the assignments
in this program.
If the "hunt-to"
[DN]
is busy, the system will try to ring the next "hunt-to"
[DN],
and so on. If a "hunt-to"
[DN]
is in the Call
;
Forward mode, the call forward will have priority over
'
the hunt. A ground/loop
stat-t CO line will hunt from a
[PDN]
or
[PhDN]
only if it has been assigned to ring at
the owner station of the
[PDN]
or
[PhDN]
exclusively
(in Programs
81 I 89, *8l,
*84, or *87).
Initialized
data does not assign "hunt-to" points for any
[DN].
Program
*33-Phantom
Directory
Number
"Owner
Telephone"
Assignments
Each
[PhDN]
must be assigned
to a designated
"Owner" telephone.
If a
[PhDN]
is not assigned to an
"Owner" telephone,
it cannot receive calls (caller will
receive reorder tone) but it can be used to originate
calls. A telephone
can be assigned
as "Owner" of up
to 240
[PhDNs],
but, a
[PhDN]
can only be "owned"
by one telephone.
[PhDN]
"Owner Telephones"
will
have the following attributes for the
[PhDNs]
that it is
assigned to own:
Set Call
Forward
for all
[PhDNs]
that
the
telephone
owns.
Set Call Forward to a VM Mail Box and Message
Retrieve
ID codes (#656/#657),
independent
of
the telephone's
Voice Mail assignments.
This "CF
to" VM Box can be the same
as the Owner
telephone's
VM Box or any other
VM Box,
including a dedicated VM Box for the
[PhDN].
Have up to four
[PhDN]
Message
Waiting (MW)
LEDs (Program
39, flexible Button). This
[PhDN]
MW button
will indicate
that the
[PhDN]
has a
message waiting from voice mail or another
[DN] -
again independent
of the Telephone's
fixed MSG
LED.
Store
ANI and/or
Caller
ID information
for
abandon calls directed to the
[PhDN].
The
[PhDN]
Owner telephone
must be assigned "Abandon Call
January
1996
9-23

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents