Toshiba Strata DK 280 Installation Manual page 448

Program 1 O-3
-System Assignments, Part 3 of 3
SELECT = 3 -J
L Buttons/LEDs
Light LEDs as defined by the table below.
ALL LEDs with an "X" should be lit when you finish.
-05 I I
042 PEKU Ports 33,34 - Amp. 4 Connected
Ports 33, 34 - Stations Connected
03 PEKU Ports 25,26 - Amp. 3 Connected
Ports 25, 26 - Stations Connected
02
PEKU Ports 17,18 - Amp. 2 Connected
Ports 17, 18 - Stations Connected
01
PEKU Ports 09, IO - Amp. 1 Connected
Ports 09, 10 - Stations Connected
Notes:
1. initialized data: LEDs 7 7 and 13 ON, a// other LEDs OFF.
2. Amplifiers are switched into two-CO line ca/ls automatically. one amplifier for each ca//. starting from the
lowest ports enabled to the highest. Skipping ports is a//owed. Two-CO line calls established after i
amplifiers are in use will not be amplified. RCTUB, RCTUBAIBB, and
Amplifiers, RCTUA allows up to 3 Amplifiers.
all
I'" set , "l-i- 1 ON
RCTUC/D allows up to 4
240 set t ON 1 OFF
3. The time the Auto Attendan; will ring .&ations (per Program 81. 84, 87) after a loop start line caller does not dial and/or a ringing station does not
answer. Set ring disconnect time as shown above. If a call is not answered before ring disconnect time period time-out, the call will disconnect.
This is to prevent loop start lines from being locked-up when there is no CPC supervision from the central office after the outside caller hangs
"P.
4. Set LED IO-13 ON so that their HEX values add up to the Voice Mail station digit length for SMDI VM interface. (Example: For Vpf 00 or
Stratagy SMDI interface, set LEDs IO, 11, and 12 on for 7 digits (1+2+4=7). LEDs lo- 13 should be off for Toshiba proprietary VM interface.
5. Toshiba Proprietary and SMDl is available with RCTUB2 or RCTUCFtCTUD2 Release 2 and above on/y and is on/y for use with Toshiba Vp
systems, not with Toshiba Stratagy systems.
6. When sending Call /D/AN/ numbers to voice mail via SMDI, LED s 08, 09, IO, 11, 12, 13, and 14 must be turned ON.
Genera/ Notes:
IMPORTANT !
Only enable the PEKU and PESU ports that are actually connected to amplifiers.
Do not install T/E/D/D lines or the RATU PCB in slots with lower slot numbers than amplified conference PEKtJ slots.
.
See Chapter 6-Peripheral /nsta//ation for COnrIeCting up to four two-way amplifiers for use on tandem, DISA, External Cal/ Fcward, DN/S
external routing, and conference telephone calls.
.
See Program 10-2, LED 18 and 19; Program 1 O- 1, L EDs 19 and 20; and Program 15-5 for more information regarding Two-CO line
conference/tandem.
lo-32
January 1996