Toshiba Strata DK 280 Installation Manual page 695

Table 13-21
Mode 95 - Remote Calling Station Messaging (Add/Review/Change)
Step
Action Display/Printout
1
Enter the Message Mode
>MODE MESG
At the
>MODE
prompt, type
MESG,
press Enter.
2 To Add Or Review a Calling Station Message m 95
Set the terminal keyboard to the lower case (caps lock off) and
type
m9
5.
General Note:
Type m anytime it is desired to start over in this procedure.
3 Type x x x (XXX = station number where the message will be
m95 XXX
set and stored).
4
Type p nn(p = page command and
m95 xxx P 00 CM1
00 = 2-digit message memory location: IO - 19 personal
messages and 60 - 99 = system message).
General Notes:
l
To store system messages permanently, DKT or EKT XXX
must be the station at port 000.
o Afterp 00 is entered, the previously stored message is
displayed. If there is no stored message, nothing is displayed.
5 To Change Previous Message
m95 xxx ~00 [M+l
Set the terminal keyboard to upper case and change message
(alphanumeric, 32 characters max.).
6 To Set the Message on DKT or EKT XXX's LCD m95 Xxx P 00 [M+l P
Set the terminal keyboard to lower case and type
pm0.
m0
-L
Zero
7 To Exit the Message Mode
m0
At any time, type
moq
(lower case).
9
> MODE
General Notes:
l
To cancel a message set via Mode 95, use Mode 97.
l
[M] represents the message entered.
l
DKT = digital telephone
EKT = electronic telephone
13-32
January 1996